What brand of tile scribe cutter do you use.? - TilersForums.com

[demi34]

Sigma for me I used them for 23 years

 

[BoldreChris]

I've put Rubi but I have to say that my TS 50L plus is a big disappointment. Hoping for great things from it but sadly it won't cut porcelain (just detonates them at the pressure point) and I use my much smaller old Plasplugs Contractor for small ceramics. Angle grinder does it best for me!

 

[lincs TTA tiler]

ts40 ,ts60 plus and my little toy TX900N :smilewinkgrin:

 

[cozmit]

Hi

I've owned a Rubi ts40 for over 20 years and it's still going strong, however, due to a rapid increase in tile sizes I've recently upgraded to a tx700n, but it needs two men and a boy just to lift it and takes up most of the room in an average bathroom. I find the very long variable angle back stop extremely useful and accurate with its nearly 600mm measured increments.

 

[besenzig]

Sigma 3CM 72cm, cos its great, made in Italy and i'm Italian...

 

[stumor]

Always reach for my Rubi

 

[NZ_Tiler]

I use a small sigma the most, so voted for that, but my large cutter is a Kaufmann. Does a good job, but weighs a ton

 

[easzeetiler]

Rubiholic me just need to sell the Raimondi.....

 

[AliGage]

I hear ya Dave, cheers!

 

[gamma38]

I have a Rubi TX900N and a Montolit 63, looking to get rid of the rubi and trying a Sigma. They seem to be appearing in a lot of suppliers around me at the moment. Could be an omen................

 

[Ian]

I have a Rubi TX900N and a Montolit 63, looking to get rid of the rubi and trying a Sigma. They seem to be appearing in a lot of suppliers around me at the moment. Could be an omen................

Is your tx900 the new model?

 

[gamma38]

Is your tx900 the new model?

Yes. It certainly is.

 

[Ian]

Yes. It certainly is.

If you're thinking of getting rid of it for a Sigma, give me a shout. I have a 3DM that is 2 months old and I just can't get on with it.

 

[DHTiling]

Got a TX700 Bri?

 

[gamma38]

If you're thinking of getting rid of it for a Sigma, give me a shout. I have a 3DM that is 2 months old and I just can't get on with it.

I'll do a straight swap if you wan't to??