Porcelain Tiles Chipping

[kenny mac]

Thanks folks I did some dry cuts on off cuts and now cutting the tiles upsides down a lot less chipping hardly noticeable

The £20 plasplugs with a general cutting blade dose fantastic cuts absolute madness

Thanks everyone the cuts are good enough I'm going to run with it

Cheers Kenny Mac

 

[Stef]

Do you rate the ATS blades above the montolit then Stef, just invested myself in a monti progress for the grinder?

The pro-gres is probably the best blade I have used but an ATS blade isn't far behind it & when the ATS blade is almost £30 cheaper then it's a no brainer.
Need to purchase one form Alan @ ATS & try them for yourself m8..

 

[Italy]

Hahaha..you on commission?
You should be able to give up on the tiling then soon, turn my pounds into euro's

hahaha yes.
if you continue like this.
in a few months I retire

 

[Spare Tool]

The pro-gres is probably the best blade I have used but an ATS blade isn't far behind it & when the ATS blade is almost £30 cheaper then it's a no brainer.
Need to purchase one form Alan @ ATS & try them for yourself m8..

Craig (Widler) gave me an ATS blade to try and I was very happy with the results untill some Italian guy on here kept banging on about the monti's so thought id see what all the hype was about, as you say for nearly four fold in the price there's not a lot in it..Think the montolit slightly better but comparing price to quality its definitely not 4 times better

 

[Spare Tool]

hahaha yes.
if you continue like this.
in a few months I retire

Sell, sell, sell retire equals more time to cycle

 

[Stef]

Craig (Widler) gave me an ATS blade to try and I was very happy with the results untill some Italian guy on here kept banging on about the monti's so thought id see what all the hype was about, as you say for nearly four fold in the price there's not a lot in it..Think the montolit slightly better but comparing price to quality its definitely not 4 times better

Couldn't have said it better myself..
Craig's a good one, always talking to him on Facebook..

 

[Spare Tool]

Couldn't have said it better myself..
Craig's a good one, always talking to him on Facebook..

No doubt he'll read this eventually so only got good things to say about the lad ...better plasterer than tiler though haha

 

[Italy]

you are talking about two different blades.
I believe that ats be similar to this.

 

[Old Mod]

I'm sure Alan @ATSDiamondTools would send you one @antonio, if you were to buy one!

 

[Italy]

I use progres for excellent finishes.
and use TCS 115 for quick cuts and good finishes.
like to try. ats to compare tcs Montolit.