- Reaction score
- 0
I have a small kitchen with a floor area of 265cm x 140cm with the door recess adding another 20 cm to the length & I have tiles that are 120cm x 20cm. I will be coating the floor with an SBR primer first because of the bitumen on there & I have some old glue residue to remove first from stuck down lino
Where should I start the whole first tile?
I can have the whole tile into the outside door recess with the next tight into the wall, this would leave an approximate half & quarter cuts s at the door into my dining room
I can have the whole tile into the outside door recess & the next tile at the middle of this tile so there is a half cut next tile into the door, & a smaller one, around a quarter tile to the wall & this would be a whole tile by the dining room door & around a half cut on the tile next to it as well
Which way would you tile the room?
I will be using KA SBR bond co-polymer to seal the bitumen as I can get a 1 litter from Wickes. What tile adhesive should I use for these long tiles, what gap should there be between them & what size adhesive trowel would you recommend
Thanks
Phil
Where should I start the whole first tile?
I can have the whole tile into the outside door recess with the next tight into the wall, this would leave an approximate half & quarter cuts s at the door into my dining room
I can have the whole tile into the outside door recess & the next tile at the middle of this tile so there is a half cut next tile into the door, & a smaller one, around a quarter tile to the wall & this would be a whole tile by the dining room door & around a half cut on the tile next to it as well
Which way would you tile the room?
I will be using KA SBR bond co-polymer to seal the bitumen as I can get a 1 litter from Wickes. What tile adhesive should I use for these long tiles, what gap should there be between them & what size adhesive trowel would you recommend
Thanks
Phil