Trowel size for 600x600 floor tiles - Tile Advice

[Doingmybest]

Morning All,

I need to lay 600x600x10 ceramic floor tiles. I was wondering what the best trowel size for the job is please?

Thanks for your help

 

[Jon_Hall]

Morning All,

I need to lay 600x600x10 ceramic floor tiles. I was wondering what the best trowel size for the job is please?

Thanks for your help

If the floor is perfectly flat, the smallest trowel I would use is 10mm notch, I would also back butter the tile. You need to get as near as possible to 100% coverage of adhesive on the back of the tile to insure it is properly fixed. If you lift a tile that you have fixed and you can still see the adhesive notches, then you haven't got sufficient adhesive coverage, so you will need to use a larger notch trowel.

 

[Doingmybest]

If the floor is perfectly flat, the smallest trowel I would use is 10mm notch, I would also back butter the tile. You need to get as near as possible to 100% coverage of adhesive on the back of the tile to insure it is properly fixed. If you lift a tile that you have fixed and you can still see the adhesive notches, then you haven't got sufficient adhesive coverage, so you will need to use a larger notch trowel.

Thanks for the help
The floor does run out. Shall I use a 20mm to be safe? Also will a u shaped trowel help with coverage?
Thanks

 

[Jon_Hall]

Thanks for the help
The floor does run out. Shall I use a 20mm to be safe? Also will a u shaped trowel help with coverage?
Thanks

A 20mm half moon trowel, may work but as I said you will need to check some of the tiles once you have fixed them for coverage.

 

[Doingmybest]

A 20mm half moon trowel, may work but as I said you will need to check some of the tiles once you have fixed them for coverage.

Great, cheers Jon

 

[Cris]

you cant go wrong with a tiger trowel for floors.... my fav

 

[Dave]

I’d be using a 12mm notch and back skim. 20mm is a deep bed imho.

 

[Doingmybest]

I’d be using a 12mm notch and back skim. 20mm is a deep bed imho.

Thanks Dave. Square or U shaped?

 

[Dave]

Thanks Dave. Square or U shaped?

Sqr is fine.

 

[Rae]

Use ten mm at the highest point then go from there ,building up from there

 

[Doingmybest]

Use ten mm at the highest point then go from there ,building up from there

Sounds good advice thanks Rae