Silicone - TilersForums.com

[Flintstone]

I've purchased a fugi kit to try out after reading about them on here, I've always been a finger and washing up liquid man and I make a good job, but, with a job coming up that requires black silicone and white tiles, I thought it might be worth a try with this kit. Question is, how do you lubricate the tool? Spray something on the silicone?

 

[p4ulo]

I didn't lubricate the tool, the washing up liquid solution will do that.

 

[Flintstone]

I mean, I normally put my finger in the washing up liquid and water and smooth it. Do you dip the tool in, or spray it on the silicone instead

 

[p4ulo]

Mix up a water / washing up liquid solution in a squeezy bottle and spray the silicone and go onto it.....it works. I must admit, before I did that, I did run along it quickly with a licked finger to push the sealant into all edges and get it stuck fast.....

 

[Italy]

I need some silicone lesson.
I'm not very enabled with silicone.
I do very little, but every time I do I problem ...
I will study on TF

 

[John Benton]

It take a bit of practice, best way is to make some internal corners, especially 3 joint corners, with cuts of left over tiles. You need to make sure you don't use too much silicon otherwise it starts getting messy.

It does take time but the finish you get is superior

First pic I had to use masking tape and the old finger as it was just not feasible to use the Fugi tool because of the relief of the wall tile

 

[hmtiling]

I just use the profiling tool. No water or anything else. Am I on my own here?

 

[John Benton]

Nope I just use tool as well

 

[hmtiling]

Nope I just use tool as well

Phew, thought I was doing it wrong

 

[Ian]

Just the tool for me too, never used washing up liquid or any other lubricant.

 

[Flintstone]

Ile give it a go then without any lubrication. I just assumed, as you can't do that with your finger.

 

[Flintstone]

That sounded a bit saucy

 

[J Sid]

I just use the profiling tool. No water or anything else. Am I on my own here?

Just use as is

 

[Andy Allen]

Just the tool for me too, never used washing up liquid or any other lubricant.

Is it not easier with some lubricant Bri..lol

 

[p4ulo]

Jeez, I must admit, internal corners still fox me. I try to do the down runs on the first occasion, then go back later (once touch dry) to do the other floor / ceiling bisecting pass.