Hi guys,
Hope you are all having a fantastic Xmas.
To cut a long story short I have installed electric underfloor heating wires under large format tiles (600x600) using ditra heat duo membrane as per manufactures instructions etc.
My question is how do I switch on the floor heating on for first time? I have read on the internet you have to increase temperature by 1° every day to maximum setting as per manufactures recommended and then gradually reduce back down gradually in the same way - is this correct?
Also once this has all been done can I from a cold day just turn the heating up to its maximum setting which is 25° recommended? Or do I have to increase each day again? I'm a little confused lol.
Any help and advice would be very much appreciated. Thanks, Gary.
Hope you are all having a fantastic Xmas.
To cut a long story short I have installed electric underfloor heating wires under large format tiles (600x600) using ditra heat duo membrane as per manufactures instructions etc.
My question is how do I switch on the floor heating on for first time? I have read on the internet you have to increase temperature by 1° every day to maximum setting as per manufactures recommended and then gradually reduce back down gradually in the same way - is this correct?
Also once this has all been done can I from a cold day just turn the heating up to its maximum setting which is 25° recommended? Or do I have to increase each day again? I'm a little confused lol.
Any help and advice would be very much appreciated. Thanks, Gary.
