cement

A cement is a binder, a substance used for construction that sets, hardens, and adheres to other materials to bind them together. Cement is seldom used on its own, but rather to bind sand and gravel (aggregate) together. Cement mixed with fine aggregate produces mortar for masonry, or with sand and gravel, produces concrete. Concrete is the most widely used material in existence and is behind only water as the planet's most-consumed resource.Cements used in construction are usually inorganic, often lime or calcium silicate based, which can be characterized as non-hydraulic or hydraulic respectively, depending on the ability of the cement to set in the presence of water (see hydraulic and non-hydraulic lime plaster).
Non-hydraulic cement does not set in wet conditions or under water. Rather, it sets as it dries and reacts with carbon dioxide in the air. It is resistant to attack by chemicals after setting.
Hydraulic cements (e.g., Portland cement) set and become adhesive due to a chemical reaction between the dry ingredients and water. The chemical reaction results in mineral hydrates that are not very water-soluble and so are quite durable in water and safe from chemical attack. This allows setting in wet conditions or under water and further protects the hardened material from chemical attack. The chemical process for hydraulic cement was found by ancient Romans who used volcanic ash (pozzolana) with added lime (calcium oxide).
The word "cement" can be traced back to the Ancient Roman term opus caementicium, used to describe masonry resembling modern concrete that was made from crushed rock with burnt lime as binder. The volcanic ash and pulverized brick supplements that were added to the burnt lime, to obtain a hydraulic binder, were later referred to as cementum, cimentum, cäment, and cement. In modern times, organic polymers are sometimes used as cements in concrete.
World production is about four billion tonnes per year, of which about half is made in China. If the cement industry were a country, it would be the third largest carbon dioxide emitter in the world with up to 2.8 billion tonnes, surpassed only by China and the United States. The initial calcination reaction in the production of cement is responsible for about 4% of global CO2 emissions. The overall process is responsible for about 8% of global CO2 emissions, as the cement kiln in which the reaction occurs is typically fired by coal or petroleum coke due to the luminous flame required to heat the kiln by radiant heat transfer. As a result, the production of cement is a major contributor to climate change.

View More On Wikipedia.org
  1. S

    Cement Board On Plastered Walls

    Hi all, First post, so please be gentle! Preping our bathroom to drag it out of the early 90s and make it a nice place to spend time in. Ripped a lot of the old tiles off to find that some moisture had got behind and blown the finish plaster coat. The wall is 50mm breeze block, 10mm bonding...
  2. M

    Tile trim for cement board

    I'm tiling (9mm) over cement board (12.5mm) around a bath and the board/ tiling will be 1200mm high, so the top will have a "bare edge". What tile trim is recommended to cover the cement board/ tile edge, or should I use something else? Thanks :smilewinkgrin:
  3. E

    Limestone tiling over a dry sand and cement screed with UFH

    Hi Guys, Im new to this forum. I am going to do a job on a new build in a couple of days and would like a little advice. I will be laying limestone tiles over a 'dry' screed of sand and cement with UFH (air to water heating system). The builder has said he had left the heating on for two weeks...
  4. D

    is there a cement faced

    tile backer board that is flexible ( pre -cut into segments to bend round ), i have never seen any , but wife is getting ready for me to do more work at home and i need some ???:thumbsup:
  5. L

    Cement Board

    Hi all, someone was telling me today that they have seen a cement board that has superior strength than ply that can span joists, anyone heard of it or is it a myth?
  6. C

    Cement dust on Indian Sandstone HELP!

    Hi, I'm repointing my indian sandstone patio with a dry mix (4:1). Tried a test area first, but when I brush the mix into the joints the dust is staining the sandstone. Is this OK?? I've brushed off as much dust as I can. The stone hasn't been sealed. Any advice would be welcome! Pete
  7. S

    Another question about cement boards and screws!

    Hi I know Screwfix turbo gold screws have been mentioned on this forum to secure 12 mm cement board. I will be using these screws to secure the 12 mm cement board to wood. But I also have to secure the 12 mm cement board to metal stud framing. Which screws do people advice please to use, to...
  8. D

    Cement

    25 kg bags of portland cement £3.10 each , can you beat that in your area ?? :hurray:
  9. M

    Sand and cement screed

    I'm on a job in hale barns. On Friday just gone the screeders came and screeded the floor. The screed is about 150mm thick with underfloor heating The floor layers have told the customer it can be tiled after 3 days as it's fast setting. Obviously I know it can't be but is there any spec I can...
  10. J

    screws for cement board

    got quite a big floorwhich needs overlaying with xl cement board(trinmline) similar to hardibacker. just found the screws delivered too long for heat pipes below. whats the best type of screw for these boards . screwfix is open and my best bet today. any suggestions
  11. M

    Cement boards on a wall

    The question I'm asking is I have a small section about 0.8 m x 0.9 m in a shower the one wall is stud so that will be ok but the other wall is block and I need to boards to be 10mm off the wall as the rest is plasterboard so my question is can you successfully Dot and dab the boards using...
  12. G

    Cement Boards....

    Hello. Not posted here for a couple of years. And am a bit dejected to say the least. So - What's the general opinion regards Tanking Cement Boards when they are fitted in a bathroom containing a shower enclosure? To clarify, I'm not talking about when they are fitted in a wetroom. Thanks, Grouch.
  13. J

    Any one had a hip replacement!

    Hi, Guys, I'm new to the forum and this is my first post! I know it's really random, but I am a tiler in need of a hip replacement desperately but I'm petrified of having it done because if it means I will not be able to tile floors etc. Only another tiler would realise the...
  14. S

    Cement boards can cause certain screws to rust

    I have read that the alkali in the cement board can slowly rust a screw over a period of time. The screwfix turbo gold screw says it is zinc & yellow passivated for double corrosion resistance. Could I please check if this screw is OK to use to fix cement boards? Or should I be using the...
  15. W

    White Cement for travertine pavers?

    Hey all, I'm laying some exterior travertine pavers. I'm aware that white adhesives are recommended for travertine tiles to avoid staining, however, I don't know if I should use white or standard cement for the exterior pavers? I guess the big difference is trav tiles are normally 10-12mm...
  16. D

    Cement board for Floor Boards

    Hi all, I just wondered which boards you use? There must be a trade off between price and quality. Thanks
  17. mz30

    sigma art 2a replacement handle

    anyone know the cheapest place to get on of these? dropped a trolley ontop of mine and its sheared off. Thanks in advance.
  18. D

    Morrocan Encaustic cement tiles

    Hi Guys I have a general question regarding fixing "moroccan cement tiles " outdoors. Used those tiles many times before internally both on floors and walls but now been asked to tile 4m x 1m section on garden brick wall , and was wondering what would be the best option to prepare the...
  19. B

    Who glues their cement board?

    Iv been taught to glue cement board then screw it, but lately made friends with a couple of tilers and they just screw it? What do the proper tilers do?
  20. L

    rubi Ti-s replacement breaker pads

    Does anyone have any idea where I can get replacement breaker pads for a rubi ti-s. thanks in advance Lee
This website is hosted and managed by www.untoldmedia.co.uk. Creating content since 2001.
Tile Contractor Forum. The useful tile contractor website.

UK Tiling Forum Stats

Threads
67,365
Messages
881,187
Members
9,529
Latest member
Dawz84
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock    No Thanks