No More Ply for laying 600x300 porcelain - TilersForums.com

[Colo]

Hello,

I am planing on using no more ply over my existing 18mm flooring to lay 600x300 porcelain tiles.

Would there be any benefit in laying 2 layers of the 6mm no more ply to create 12mm covering.

Will this make the floor stronger or is the 6mm enough.

The joist are 8x2 at 16inch centres with a span of 10ft. There is no noticeable deflection when tested with a laser and the 18mm floor is in good condition

Any advice is appreciated.

Thanks

 

[hmtiling]

Hello,

I am planing on using no more ply over my existing 18mm flooring to lay 600x300 porcelain tiles.

Would there be any benefit in laying 2 layers of the 6mm no more ply to create 12mm covering.

Will this make the floor stronger or is the 6mm enough.

The joist are 8x2 at 16inch centres with a span of 10ft. There is no noticeable deflection when tested with a laser and the 18mm floor is in good condition

Any advice is appreciated.

Thanks

6mm nmp will add a bit of strength to the floor which i'm assuming is chipboard. 2 layers will definitely add more strength. depending how bad the deflection is i'd consider adding noggins and more fixings or using Blanke Permat.

 

[On one]

It doesn't follow that two layers of 6mm would necessarily have the same strength as one 12mm board.
Two 6mm layers might be stronger,but no need to double up on NMP.

 

[Dumbo]

If you double layered you could overlap joints of first layer with second layer . Got to be some merit in that

 

[Cranbrook]

Hello,

I am planing on using no more ply over my existing 18mm flooring to lay 600x300 porcelain tiles.

Would there be any benefit in laying 2 layers of the 6mm no more ply to create 12mm covering.

Will this make the floor stronger or is the 6mm enough.

The joist are 8x2 at 16inch centres with a span of 10ft. There is no noticeable deflection when tested with a laser and the 18mm floor is in good condition

Any advice is appreciated.

Thanks

Just checking but you do realise you can get NMP in 12mm rather than having to put 2 layers of 6mm down?

 

[hmtiling]

Just checking but you do realise you can get NMP in 12mm rather than having to put 2 layers of 6mm down?

2 x 6mm will be stronger than 1x12mm.

 

[Time's Ran Out]

How much is NMP + glue?

 

[Cranbrook]

2 x 6mm will be stronger than 1x12mm.

Id say only marginally, and with joists at 400 centres like the Op has then 12mm boards would be sufficient, in my humble pinion of course

 

[hmtiling]

Id say only marginally, and with joists at 400 centres like the Op has then 12mm boards would be sufficient, in my humble pinion of course

Actually, if you read nmp's literature then you'll find that overboarding with 6mm and 12mm adds the same strength according to them. Cross laminating them would add far more strength in my opinion. To strengthen the floor permat would be the way to go

 

[hmtiling]