Tiles Chipping With A New Blade

[py rookie]

Hi peeps I'm having trouble with tiles called tones,Johnson's tiles,when I use my grinder with a brand new blade on it,the tiles are chipping,especially around the window,any advice would be great ta

 

[Dan]

Change your thread title. Try to be a bit more informative with your titles, as "Advice needed" could apply to every single thread on the forum, so people don't know what your thread is about before visiting it. If you put "grinder with chipping tiles" in it, somebody who's had the same issue will quickly spot it and perhaps respond.

 

[Chalker]

Segmented, or continuous rim blade?

 

[Andy Allen]

Are these the cheapy johnsons tiles from the diy sheds?

 

[py rookie]

I bought a marcrist ck 850,they are Johnson's tones tiles yeah look cheap

 

[Andy Allen]

I had that blade in my cutter......seemed to chip tiles aswell especially the cheap crap ones...

I find the blades i use for cutting most decent tiles tend to chip the really crap tiles must be the thin glaze on them..
Got round it once by borrowing a customers cheap crap wet cutter....cut them a treat!!!
Moral of the story...cut crap tiles with a crap cutter....

 

[Unused Account 1]

Hi peeps I'm having trouble with tiles called tones,Johnson's tiles,when I use my grinder with a brand new blade on it,the tiles are chipping,especially around the window,any advice would be great ta

When getting a new blade run it through some travertine ,seem to bed it a bit ,with it being natural stone

 

[Dave]

Scribe your L-cuts and then cut into the corner of the scribed lines a couple inches or so away from the scribe , then Break both pieces out with your dry cutter.

Nice clean edges then.

 

[AD Ceramics]

I bought a marcrist ck 850,they are Johnson's tones tiles yeah look cheap

Try holding a damp sponge against the blade while cutting it to keep it cool. I do it quite a bit if I can't be bothered setting my wet saw up.
Be careful what though.

 

[mattle40]

I've heard ck850's are very good but I really didn't get along with mine, chipped loads. If I was trying to do a particularly thin L cut (20x10 around a socket) then I had no chance at all, vibration just broke the tile. Maybe I had a bad one.