Search the forum,

Discuss The Best Outdoor Adhesive? in the Tile Adhesive / Grout Advice area at TilersForums.com.

S

Sporty

Hi guys

That's the adhesive I need then is it Tom?

The only place I know of is Topstiles. That's the go to tile shop that I know of....Dave

As for falls, there is a. Slight one heading towards the gully. I screeded a four and one mix in the patio area, ready for my marble. I did that last summer so obviously, apart from a sheet, is open to the elements for the winter. It looks to be holding up ok, even though it's permanytely wet!

Si
 
R

Rizzle from the Portizzle

ok the best would have been to lay it into the wet screed but even then you are taking a big risk laying marble out side in the uk you could not be using a worse tile .it will take in water crack and faid in no time the question you should be asking how can i seal this against the uk weather.the faiding you cant .but the water ingress you stand a chance very little over time .you need to tell them that marble is not for out side use in the uk
 

Reply to The Best Outdoor Adhesive? in the Tile Adhesive / Grout Advice area at TilersForums.com

Make sure to mark a post as a solution for better transparency.

There are similar tiling threads here

  • Question
I've got an AKW Tuff form shower tray with a waste that is 10mm above the tray when fully screwed in. The Tiler laid my 5mm hex mosaic tiles on a 2mm bed, so obvs wasn't going to drain. I took...
Replies
6
Views
2K
    • Like
  • Question
Hi, I am planning on tiling my concrete garage floor with porcelain tiles. The concrete was laid down several years ago by a previous owner, and it looks like it was also polished and sealed -...
Replies
2
Views
1K
  • Question
Hi, I‘ve just finished tiling the majority of my garden path. Base is concrete, and tiles are porcelain. I’ve just got to the end of my bag of Mapei flexible rapid set tile adhesive (powdered)...
Replies
0
Views
821
  • Question
Hi all, I am planning to tile a full height panel of split face tiles to sit 3” behind a log burner on a plaster render on blockwork wall. I’m planning to score and scrape the paint off the...
Replies
5
Views
1K
  • Question
Hi, I'm new to the forum and fairly new to tiling, my only previous "proper" job was my recent bathroom (600x600 porcelain, about 25m walls and floors) which went pretty well. I'm now having a go...
Replies
3
Views
2K

Advertisement

Top