My 1st Job Which one? - DIY Kitchen Tiling Job :) - TilersForums.com

[Tony_C]

Yes rule of thumb is to center with the hood as its a more focal point, providing it leaves you with good cuts into the sockets and ends. You can adjust what row is full or half tile to make the sockets easier also. That may seem obvious sorry but its not to everyone
[automerge]1570879619[/automerge]
This thread will be of some use to you also for that control panel/socket to the far right as it's a little different to your normal socket

How do I tile around switches and sockets? - How to tile properly around sockets

Hi How do you get a better finish with the below switch please

www.tilersforums.com

 

[Dumbo]

How unlevel is your worktop . It has to be really bad . Also for your bottom row of tiles would have to be cut at an angle for that reasoning to have any value .

 

[Dave]

Also , if you have enough depth in the window frame , dab some plasterboard on the cill to full tile.

 

[Dumbo]

Also , if you have enough depth in the window frame , dab some plasterboard on the cill to full tile.

Was looking at that option also as he has quite a large margin at the bottom of the window sill

 

[Faithfull]

How unlevel is your worktop . It has to be really bad . Also for your bottom row of tiles would have to be cut at an angle for that reasoning to have any value .

It's an L-shape. One side is ok but the other side with the window frame runs down into the corner by 22mm over a 3m length.

 

[Steve6690]

lesson from a professional instructor