Rubi ND200 cutting off line help??? - TilersForums.com

[peckers]

I have a Rubi ND200 and it wont cut strait. as you push a tile threw it the blade twists at an angle it even does it when you push on the front of the blade with your fumb(motor not running) it is as if the spindle is moveing sideways. is it on a rubber mount or a bearing?
is there a fix for this or is it a new machine required?
It hasnt had a great deal of use but is out of warranty.

 

[Gazzer]

What is a "Fumb"

 

[peckers]

What is a "Fumb"

oops thumb lol

 

[Time's Ran Out]

I had one for 16years - great machine.
Always had a line on the tile to cut too and rarely used the guide rail.

 

[peckers]

I had one for 16years - great machine.
Always had a line on the tile to cut too and rarely used the guide rail.

I normally cut to a line too but even when using the guide rail it still wont cut strait. and it seem to go off very quick its not as if it got worse over a period of time. you can push the blade sideways with your thumb about 5mm