Search the forum,

Discuss Floor tiles debonding after UFH turned on in the Canada Tile Advice area at TilersForums.com.

Ajax123

TF
Esteemed
Arms
931
1,213
Lincolnshire
Im assuming that this is an install that you have done for the builder. If so It sounds to me like you've answered your own questions here.

1. Decoupling was agreed but not supplied so thats a breach of contract.
2. You guaranteed the tiles would not fail as a result and they have failed somthats a breach of guarantee.
3. The floor was clearly wet and probably too wet to tile directly. I'm assuming no moisture test done which is a failure to observe due diligence.
4. The underfloor heating was not commissioned prior to tiling which fails to meet the required standard of best practice.
5. Plaster left on the floor prior to tiling shows lacking adequate preparation which is also a failure to meet the required standard if best practice.

If I were you i'd be doing everything reasonable to sort it out. Ie. Lift and replace the tiles at your cost. If it went to litigation you would not have a leg to stand on. It would not be diffucult for the builder to prove to a court that it is your fault regardless of what temperature the heating went on at.
 

Reply to Floor tiles debonding after UFH turned on in the Canada Tile Advice area at TilersForums.com

There are similar tiling threads here

I had a small leak in the main water line before the stop tap in my 1950s house. The copper pipe...
Replies
1
Views
782
    • Like
Hi, I am planning on tiling my concrete garage floor with porcelain tiles. The concrete was laid...
Replies
2
Views
1K
Further to my other post re our hollow tiles issue It looks like our tiler has dot and dabbed...
Replies
6
Views
2K
    • Like
Hi, Can't seem to find a solid answer as I realise so much depends on multiple factors. I'm...
Replies
0
Views
2K
Hello there, Relatively recently we had a new en-suite fitted (complete rip out of the old...
Replies
5
Views
2K

Advertisement

Replies you've not seen

Top