Setting out brick bond from natural centre point causes thin cuts

[SlippySlipster]

Hi,

I was looking for a bit of advice i have read various posts on here regarding brick bond layouts and several say to avoid having slithers everywhere.

I was wondering what constitutes a slither!!

I have mocked a layout up on my PC (See below) and using a desirable starting point centred to my extractor fan; it would appear that i will be left with two thin cuts into the internal corners.

I have ran my layout around the rest of the room and it seems that the only way i can avoid the thin cuts is to have a strange centre starting point which makes the focal point of the kitchen hob / extractor be not centred in the brick bond.

My tiles are 200 x 100 x 7mm Metro beveled tiles in two colours separated by a 10mm Brushed Steel pencil bar 2mm Grout lines.

Looking at my layout do you think the short 20mm / 10mm cuts are too small and if so how would you correct the issue?

I'm new to tiling and strictly a DIY'er so any advice would be helpful sorry for any stupid questions.

Thanks in advance
Jon

 

[DHTiling]

Try a 3mm space ..

 

[SlippySlipster]

Thanks Dave,

May have had a can't see the wood for the trees moment never crossed my mind about changing the gap...

I adjusted my layout to a 3mm gap and now i have a gap to the left of 12mm and on the right 8mm on the full tile row the half tile is spot on now.

How do you get round that do you use the depth of the tile on the other wall and a bit of extra grout?

 

[Time's Ran Out]

I'd work the full tile from the worktop (assuming level) and down to the floor.

:welcome: And enjoy!

 

[Colour Republic]

Just a quick one. Have you measured the tiles they could be 198x98's

 

[Diggy]

Try measuring 50mm from the centre line and start your tile joint from there and see what you get.

 

[SlippySlipster]

Just a quick one. Have you measured the tiles they could be 198x98's

Hi,

I just checked and they are 200 x 100 6mm at the edge and 7mm in the centre.

 

[SlippySlipster]

Thanks Diggy,

I will give that a try and left you know the outcome

 

[tommyzooom]

Try measuring 50mm from the centre line and start your tile joint from there and see what you get.

This is what I'd reccomend. You will have a 3/4 tile cut and a 1/4 cut on one row, and the same cuts reversed on the next row...It still looks centred when finished.

 

[Protilers]

i would go with what you have.......(centre of cooker/extractor)........as long as your wraps are correct....the "slithers" wont be visable....and it will look better overall!