Grinding confusion

[Flintstone]

You dropped one there showing her that didn't ya!

 

[Tile Shop]

And to test my cutting abilities, for the floor we're having the Marazzi Denver beige 60x30, brick bond, with a 1 inch border cut from the black tile of the same range.

Good job i like a challenge but will be a good test for a beginner.

Also need to practice mitering with the grinder too..... for the window reveals. Luckily i have plenty of tiles to practice with before i start.

 

[Flintstone]

 

[Old Mod]

, with a 1 inch border cut from the black tile of the same range.
.

you're going to have a 1inch border around the perimeter?
Not a good idea mate, not unless you can guarantee the room is perfectly square or the area that you're tiling is.

 

[Tile Shop]

you're going to have a 1inch border around the perimeter?
Not a good idea mate, not unless you can guarantee the room is perfectly square or the area that you're tiling is.

It won't be up against the wall. It'll be set in by about 300 ish, so if the walls are on the wonk, i can lose it in the cut without compromising the layout.

I need to loose lay them when i bring them home, so will do some trial cuts and post some piccies up and take some expert ideas and guidance.

 

[Italy]

I use this

 

[moomarine]

I got one of these a while back from amazon link below:

HERZO 115/125mm Plastic Dust Extraction Cutting Guard for Angle Grinder https://www.amazon.co.uk/dp/B01G501XTK/ref=cm_sw_r_sms_c_api_.M0pyb038SFM6

But I have so far never even tested it out!

 

[moomarine]

You can't get this bit of kit anymore can you?

 

[Old Mod]

You can't get this bit of kit anymore can you?

Apparently not.

 

[moomarine]

Apparently not.

It's a shame because it looks good. Hate using my wet cutting when I can't cut outside!