Does anyone recognise the make of this expansion trim?

[All Squared Rob]

Help!

We are taking over a job where another firm has been kicked off and we need to match the expansion trim shown in the picture attached.

It has an 8mm visible edge including the stainless steel (the rubber is only 5/6mm) and needs to have a depth of 15mm

We've never seen trim with the square punch holes on the anchoring legs, does anyone on this forum recognise it or even better tell me where to source it?

 

[Blunt Tool]

Hard to tell by photo but have a look at @Schlüter-Systems Ltd range, does look very similar.

 

[On one]

The Schluter trims I have seen don't have the four 90 degree internal angles on the wings seen in the pics.

 

[All Squared Rob]

Schluter were our first port of call, and they do not manufacture in that size.

Schluter also use their logo as a punch so their trims are easily identifyable

Thanks all the same

 

[Italy]

I used these, but I'm in aluminum.
The first and the last hole is round.
The ones in the middle are square as the picture.
Movement joints and joint coverings | Cerfix® Projoint DIL NA - NO - http://www.profilpas.com/en/products/range/g/Movement%20joints%20and%20joint%20coverings/Cerfix%C2%AE%20Projoint%20DIL%20NA%20-%20NO?idc=01G0&idi=02G0&idg=03G4

 

[Italy]

Sorry, Are 17 mm wide