Laying out on tiled bath panel - Tile Advice

[LEH]

Quick one to check I'm on the right track -

I'm planning to do a tiled bath panel (with access panel using some Schluter magnets). Am I right in thinking I should have cuts below the bath rim and cuts down onto the floor?

It'll be about 560 mm high, tiles are 200 mm high, so I'm thinking to have two whole tiles centered on the grout line and then cuts top and bottom of about 75 mm?

 

[Qwerty]

Sounds good to me. Any photos ?

 

[Dumbo]

If you are have other tiling in your bathroom of the same tile your grout lines should line up with the existing tiling

 

[LEH]

Great. No photos yet as I haven't got stuck in yet but I'm sure I'll be on here again...

Yes - I'm doing a vertical stripe up the middle of decor tiles, so that very obviously needs to line up, also the bath panel has to line up with the adjoining wall at one end, so I'll be working out all the laying out together before starting.

 

[GAZ5518]

Horizontal datum line from wall tiling should determine where your bath panel lines will be..