18mm WBP ply prior to tiling - Tile Advice

[Andy Allen]

Don't forget the washers...

 

[chris_elevate]

Yes - penny washers sound good - thanks

Warmup are specifying 10mm insulation boards to comply with british standards for tiling. Do you guys agree or will 6mm be ok? I'm desperately trying to keep the bathroom floor height down as much as possible that's all.

Thanks again.

 

[Qwerty]

6mm will be absolutely fine

 

[hmtiling]

So 4mm notched trowel onto the 18mm ply with the s1 adhesive, 6mm insulation boards onto that, screws every 200mm, glass fibre take along the joins and it’ll be ready you’d say?

Go 8/10mm trowel to stick the boards and walk on them. Trowel all in the same direction along the width of the board so it's easier for the air to escape

 

[Qwerty]

Go 8/10mm trowel to stick the boards and walk on them.

I'm not the only one that likes doing that then Something satisfying about the feel & sound..... its like popping bubblewrap

 

[Dumbo]

I'm not the only one that likes doing that then Something satisfying about the feel & sound..... its like popping bubblewrap

I tread it in . I dont care if its not perfect finish as long as i have a good bond as i going to latex over it

 

[Dumbo]

This is tiling on ply