cement

A cement is a binder, a substance used for construction that sets, hardens, and adheres to other materials to bind them together. Cement is seldom used on its own, but rather to bind sand and gravel (aggregate) together. Cement mixed with fine aggregate produces mortar for masonry, or with sand and gravel, produces concrete. Concrete is the most widely used material in existence and is behind only water as the planet's most-consumed resource.Cements used in construction are usually inorganic, often lime or calcium silicate based, which can be characterized as non-hydraulic or hydraulic respectively, depending on the ability of the cement to set in the presence of water (see hydraulic and non-hydraulic lime plaster).
Non-hydraulic cement does not set in wet conditions or under water. Rather, it sets as it dries and reacts with carbon dioxide in the air. It is resistant to attack by chemicals after setting.
Hydraulic cements (e.g., Portland cement) set and become adhesive due to a chemical reaction between the dry ingredients and water. The chemical reaction results in mineral hydrates that are not very water-soluble and so are quite durable in water and safe from chemical attack. This allows setting in wet conditions or under water and further protects the hardened material from chemical attack. The chemical process for hydraulic cement was found by ancient Romans who used volcanic ash (pozzolana) with added lime (calcium oxide).
The word "cement" can be traced back to the Ancient Roman term opus caementicium, used to describe masonry resembling modern concrete that was made from crushed rock with burnt lime as binder. The volcanic ash and pulverized brick supplements that were added to the burnt lime, to obtain a hydraulic binder, were later referred to as cementum, cimentum, cäment, and cement. In modern times, organic polymers are sometimes used as cements in concrete.
World production is about four billion tonnes per year, of which about half is made in China. If the cement industry were a country, it would be the third largest carbon dioxide emitter in the world with up to 2.8 billion tonnes, surpassed only by China and the United States. The initial calcination reaction in the production of cement is responsible for about 4% of global CO2 emissions. The overall process is responsible for about 8% of global CO2 emissions, as the cement kiln in which the reaction occurs is typically fired by coal or petroleum coke due to the luminous flame required to heat the kiln by radiant heat transfer. As a result, the production of cement is a major contributor to climate change.

View More On Wikipedia.org
  1. J

    removing cement based adhesive from anhydrite screed

    got a job coming up where the stone floor has failed to a degree. anyway i have to take up the existing limestone which was bedded in cement based si adhesive. when doing a test some of the adhesive comes off anhydrite screed and some stays stuck to screed. i think best way forward is to take...
  2. aussie tiling

    Cement Sheet Cutter / Hardie Backer Board Cutter

    aussie tiling published a new article: Read more about this article...
  3. A

    Wall Tiling - The sand & cement method

    found this video clip a while back with Mr Hobson.. its old school wall tiling using sand and cement..I laboured for my dad on Merchant Taylors school in Crosby during the summer holidays of 1984 and after that job, i decided tiling wasnt for me lol..All the shower areas were done in this...
  4. O

    Once and for all (hopefully!) CEMENT Boards Explained

    It feels like there is a constant asking about the suitability of cement board in wet areas. "Will they be ok in my wet room?" "Should I tank them?" etc etc etc Can I attempt to clear up the confusion - much of which comes from the manufacturers and the builder's merchants who sell the stuff...
  5. Stevev

    3mm tub adhesive versus cement ad

    What is the advantage of using tub adhesive which typically is spread at a 3mm thickness over cement adhesive which I was trained to use at a thickness of 8mm. I was told once the tub is open it starts to go off and a slow/amateur tiler would be better with cement adhesive. Discuss!!
  6. H

    Cement tiles on walls

    Hi everyone I have purchased just over 2 square metres of 18mm thick encaustic cement tiles to use as a kitchen splashback in several different areas. As far as I can see I am yet to find a tile edger that is thick enough to hide the edge (which is rough) of the tiles +adhesive. Photos I've...
  7. I

    Isomat UK Fast-setting, self-leveling, polymer modified cementitious screeds

    For more screed options please visit our web site www.isomat.co.uk Fast-setting, self-levelling, polymer-modified cementitious screed, used for smoothing and levelling concrete or mortar floors, before laying finishing materials like ceramic tiles, moquettes, parquet, vinyl tiles etc. It can be...
  8. A

    Floating floor replacement

    Hi. I've discovered I'm the not too lucky owner of a Floating Floor, 18mm chipboard on 25mm insulation, supported by concrete "block and beam" I'm having a new kitchen and when the old tiled floor came up (slate on 18mm chip ply) we found the dreaded floating floor below. The old floor had...
  9. U

    Slow Set

    Hey guys what slow set addy you guys using at the moment ,mainly porcelain ,cheers
  10. andy-p

    Removing Grout Stains From Encaustic Cement Tile

    Fixed 15m2 of handmade encaustic cement tiles supplied by the Cement tile shop and like a complete jackass went and grouted tiles before sealing , after cleaning up saw that tiles were stained then checked suppliers website only to find out seal before grouting , is there a cleaning product that...
  11. P

    How To Remove Tiles/screed/cement Which Has Been Laid On Top Of Victorian Hearth Tiles?

    In the course of getting my living room floor restored, I've discovered that underneath the boring old terracotta tiles on the fireplace hearth are some attractive patterned Victorian tiles. However the terracotta tiles have been fixed on top of them, with what looks like cement. Is it possible...
  12. M

    Water UFH Will Pump/alternative Replacement

    My wilo pump typ RS25/5-3 is u/s. Does anyone know where I can get a replacement or suggest an alternative? Thanks Blair
  13. L

    Quarry Tile Replacement?

    Hi all, hoping you can help. We had to dig up some new-ish quarry tiles in our utility room to put in some underfloor heating. Unfortunately most of them got broken in digging them out, and we now need to replace them. Does anyone have any idea what sort they are? Dimensions 149 x 149 x 13mm...
  14. A

    Sand And Cement As Adhesive?

    Hi guys just a quick question, are you able to use sand and cement as a tile adhesive instead of the modern day 'tile adhesive'..because basically i have been to many countries where they use sand and cement in installing tiles and they seem to last donkeys years with no cracking or any problems...
  15. G

    Looking For Uk Partner To Supply Cement Encaustic Tiles From India

    Looking for UK Partner / Dealer / Importer / Trader for supplying Cement Encaustic Floor Tiles
  16. D

    Very Smooth Cement Substrate

    Hi. I'm tiling the four walls in my bathroom. It was previously tiled half way up and where I removed those, the old plaster(?) underneath was like soft pumice, so I hacked it off and re plastered, primed with SBR and tiled the lower half of the room using Mapei cement based adhesive. The top...
  17. O

    Bal White Star Or Cement Based Adh?

    As above which type of adhesive would you suggest for fitting some Fired Earth Malacassa glacier brick glass tiles above an Aga? From a heat resistant point of view and from a fitting point of view(I guess these tiles will be 6mm paper faced opaque glass and quite brittle and won't be able to go...
  18. L

    Tile replacement

    Right lads went to see a job today in 5 star hotel 3 tiles need to be replaced in 3 different bathrooms 1 on the wall with bath tap in it and shower screen 1 on the wall with shower sreen on it 1 floor tile So how much you think i should quote them
  19. J

    is sand /cement fibrous screed dry enough to fix on to ?

    How do you judge whether a screed is dry enough to tile on to
  20. Z

    Plywood Or Cement Board

    Hi I have a 200 sq m space to tile , on an existing mezzanine floor. there is slight movement in places not much though. I am wondering what the experts here would recommend to use prior to tiling plywood or cement board [no more ply ] any input / advice would be appreciated.
This website is hosted and managed by www.untoldmedia.co.uk. Creating content since 2001.
Tile Contractor Forum. The useful tile contractor website.

UK Tiling Forum Stats

Threads
67,337
Messages
881,117
Members
9,528
Latest member
Alex Carr
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock    No Thanks