Recent content by Skipp3r
-
UFH and latexing pricing.
Was a pain, but the builder is a mate, so felt obliged to use what I could. Still had to buy more adhesive after all that. Anyway it's all done. Now onto a proper floor, all 130 metres of it !! -
UFH and latexing pricing.
What about charging extra for having to sieve the latex with my garden sieve because the builder didn't cover the materials properly outside! Worked a treat sat on my tilemaster bucket. -
-
UFH and latexing pricing.
Just finished job off where I've had to install UFH mat as well as latex before and after. Normally I charge a nominal fee if it's a small bathroom. But this was a kitchen floor so I want to get a idea what people would charge say per square metre for installation of Devi and latexing. Many... -
Wet Room Advice Please.
First I'm doing on my jack yes. The tanking kit arrived today (Impey) So I'm not so in the dark now, as have used before.- Skipp3r
- Post #3
- Forum: Tanking and Wetrooms Forum
-
Wet Room Advice Please.
Hello all, I'm due to start a wet room with a former. The room is having underfloor matting. Can someone give the correct procedure for each stage, and can I ditra over the former or am I going to lose my falls. I was going to cement board or similar up to the tray. Should I lay the underfloor...- Skipp3r
- Thread
- advice room wet wet room
- Replies: 2
- Forum: Tanking and Wetrooms Forum
-
-
Tiling Anhydrite screed with wet UFH
In my experience, once the 'milk' (latience) was removed with a circular grinder, it was a good to then prime floor with acrylic Weber primer with two coats in a crossways fashion ( first coat up n down second coat left n right) then ditra. This has been our remedy on multi million pound houses.- Skipp3r
- Post #37
- Forum: Adhesive and Grout
-
-
-
Newbie in West Berks
Absolutely, always learning and can always advise.- Skipp3r
- Post #17
- Forum: The Welcome Forum
-
Newbie in West Berks
Thank you mate, it seems a great source of info.- Skipp3r
- Post #15
- Forum: The Welcome Forum
-
115mm dia diamond blades
The Bosch looks the part, might have to purchase one. Using a Rubi which is quite robust but always looking for better ;)- Skipp3r
- Post #10
- Forum: Tile Tools | any Country any make any model
-
Acceptable floor tiling or not?
If the tiles are going up on walls or going down on floors with size issues, its always best to inform the client as you go along. Naff spacers can also cause problems. -
This website is hosted and managed by www.untoldmedia.co.uk. Creating content since 2001.
