Rubi Rubi TX-900-N vs Rubi TX-900 STANDARD - Tile Advice

[JordanLincs]

I bought the TX-900-N and it's faulty I think When sliding the cutter arm on the rails, near the top end its very stiff. Re-oiled and made no difference.

 

[The Tiler]

I've had the TX 900 N for over ten year and is a very good cutter but the case is looking a bit worn out now

 

[Unused Account 1]

The case doesnt do the cutting lol ,last well if looked after

 

[Albert]

I bought the TX-900-N and it's faulty I think When sliding the cutter arm on the rails, near the top end its very stiff. Re-oiled and made no difference.

You don't oil, clean the rails and try dry lube

 

[Unused Account 1]

I wd40 after use had a ts 13 years

 

[JordanLincs]

You don't oil, clean the rails and try dry lube

I spoke to Rubi Rep who advised WD40 the rails, clean off WD40, then use 3in1 oil to lubricate

I changed cutters and this one works perfectly

 

[Albert]

I spoke to Rubi Rep who advised WD40 the rails, clean off WD40, then use 3in1 oil to lubricate

I changed cutters and this one works perfectly

Which rep?

 

[JordanLincs]

Which rep?

Not sure I should mention his name.