I bought a laser liner laser level 3 years ago and can honestly say i have used it less than dozen times switched it on before xmas and it is out of level does anyone know if they can be repaired? it hasnt been knocked or dropped

you should be able to get it calibrated gary

Hi Gary you will be able to get it calibrated bought a hilti second hand and got it calibrated cost £60 that was about 3yrs ago could get expensive it it needs repairing

where would I need to take it to get it calibrated ?

Hi Gary, contact the laser manufacturer to seek recommended calibration comps..

How much is it out..?... most makes are + - .05mm over lnr mtr..

Originally Posted by Dave

Hi Gary, contact the laser manufacturer to seek recommended calibration comps..

How much is it out..?... most makes are + - .05mm over lnr mtr..

not sure how far out it is but it is clearly obvious to the eye when comparing it to my dewalt laser i guess about 2-3mm over 1,5-2m so pretty poor it does have a tilt feature which may be interfering with the self leveling ??? I will have a look on line to see if i can get it repaired

I bought my laser off these and they recalibrate http://www.laser-level.co.uk/calibration.html