Hi does anyone know where the best and cheapest place to get a marcrist drill set??

Tradetiler.....


Have you looked at the 365 porcadrills.?

Yes, I have a set now. Great drills. I just need to pick up the pace a little. Hard as porcelain, hundreds of holes to drill equals lots of time. I keep reading how quick the marcrist are so I thought it was time to upgrade.

No probs... try here then>>>>>>Tradetiler Tile Marcrist PG850 Porcelain tile drilling system

Cheers i'll have a look. Are they as good as all the reviews say, as in quick, long lasting etc?

I have not personally used them but a few members have, await replies if you want feedback

I have a set of Marcrist and they are good but rarely use them as my 365 drills cope with everything so far.

Cheers, Thanks for the quick reply, just had a look on there site and they seem reasonably priced.

I was using a sigma 60mm core drill bit today and it was unreal on 30mm marble!
I was using it alone to cut out shower valves from slabs, very quick and sharp.
The sigma look a bit like the marcrist.

Was that with any water on the cutter...

montolit cutters on an angle grinder have been the best by far that i have used so far

i have used marcrist,365 drills and rotozip cutters all are good as well

We were using the sigma with no water, eating through 30mm marble with ease and no heating up. It was good and thick too!
We had 4 grinder/ polishers in action and dust everywhere, lol.