Folks,

I have just purchased the Rubi ND180 and noticed on the spec that the max tile cut is 350mm. I didn't check this before buying, as I thought these cutters would cut any length of tile... I am just a keen DIYer and laying 300x600 in my downstairs toilet, and concerned I am not going to be able to cut these lengthways, which was my requirement.

Have I gone and got the wrong model here ?? If they do have a length restriction, is there any way of getting around this ??

After reading a few threads it seems like the Norton Clipper TT200EM would have been a better purchase (max length shown as infinite)

Cheers in advance for any help...

Ace forum by the way...

Cheers

Paul.

If you check the Rubi website, it says on there that the max length for the ND180 is infinite too.....

You're fine mate; Review: Rubi ND180 BL electric tile cutter..

It'll cut any length.

Cheers guys

I think your mistaken max length with max depth which is 35mm.

I have one of these. good buy for the money I think but I suggest using a bottle, jug to fill the water reservoir rather than pulling it out coz its a bugger to get in and out!

it's really a guide size,sometimes the tile won't go through the guard rail at the back but you can turn the tile round and meet in the middle

Just put a good blade in it

It is awkward to handle a 600mm tile on my ND200, so it'll be harder on a smaller model..........but with a decent blade and a full water tray, take it easy and don't rush the cuts.......your'll be fine

Cheers guys... start tomorrow, and will keep in mind your advice...