Sticking new sponge for wash boy

[ECT]

Any suggestions for best glue to stick new sponges on.

[grumpygrouter]

No more nails?

[Dave]

I use the spray contact adhesive.........



summit like this one.....works in mins...make sure the sponge board is dry...spray board and sponge leave for a couple mins then stick together....

[Sir Ramic]

As usual, what Dave says. I use it all the time and a can lasts ages.

[enduro]

Originally Posted by Dave

I use the spray contact adhesive.........



summit like this one.....works in mins...make sure the sponge board is dry...sparay board and songe leave for a couple mins then stick together....

That's the one i use as well

[NETT Darren]

Thats the one i use as well, for the best results, spray the plastic float then spray the sponge as well, leave for about 1 minuite and put the two together, job done, be carefull when you run the sponge through the rollers that you dont rip off the sponge from the float

[CJ]

As above regarding the spray glue.

Also..........when filling ya washboy, DON'T make the water toooo hot, as it melts the glue and the sponge falls off into ya lap ok ok......we've all done it.

Have'nt we

[sWe]

Originally Posted by CJ again

As above regarding the spray glue.

Also..........when filling ya washboy, DON'T make the water toooo hot, as it melts the glue and the sponge falls off into ya lap ok ok......we've all done it.

Have'nt we

Not me, cuz I use cold water

[Dave]

I use cold as well.....

why so hot CJ..?

[grumpygrouter]

Cold for me too. Don't normally have hot water available, anyway wouldn't it make the grout go off quicker?

[CJ]

I don't mean scorching hot.

But if there is warm water available, I'll use it for a final wash. Only because it's gonna dry off a bit quicker so the floor can be dry wiped. Just sometimes as I have asbestos hands..........the water is a bit tooo warm and the sponge has dropped off..........twice into my lap