Cutting a 3 way mitre with tile trims.

[Dave]

This has been discussed a few times and i found this video that might help those that need help/advice on this way of mitre'ng trims..

[Topo]

It looks great and easy to do but you didn't say where the first peice, second, and third go?

[Sir Ramic]

It looks great and easy to do but you didn't say where the first peice, second, and third go?

I before the E... and I am sure you can work out what piece goes where !

[Topo]

u now wot I mean

Will work it out m8 but it would have been easier if you explained in the video.

Cheers

[Sir Ramic]

u now wot I mean

Will work it out m8 but it would have been easier if you explained in the video.

Cheers

Maybe you should go to the original You Tube clip and ask him.

[Dave]

The video was not made by us.... and IMO it is plain to see in the video how to do it... well for a tiler it should be..shall i say.

[tictic]

forgot i put this video on u tube lol.....

topo...com on its all there for you....

ps..Dave there is another one i did,...putting a few holes in a ceramic tile with pin hammer and claw hammer...old school....maybe you could put that one up also...am carp at doing all that computer stuff...

[Topo]

Yes I think I worked out when to cut the mitre vertically and when to cut it flat. It doesn't come out perfect though but I file them to match. I will show you pictures soon.

Sorry about the confusion earlier

[Sir Ramic]

forgot i put this video on u tube lol.....

topo...com on its all there for you....

ps..Dave there is another one i did,...putting a few holes in a ceramic tile with pin hammer and claw hammer...old school....maybe you could put that one up also...am carp at doing all that computer stuff...

Well ok but we have How to drill holes in hard tiles with diamond core holesaw drilling bits these days for holes

[jwatson]

to get a 3 way mitre to work. firstly the corner to be tiled has to be perfectly square and plumb,and the trim has to be a proper quadrant, if not custom cut needed.

Yes I think I worked out when to cut the mitre vertically and when to cut it flat. It doesn't come out perfect though but I file them to match. I will show you pictures soon.

Sorry about the confusion earlier

[jwatson]

thanks for the vid sir ramic..... 7 days after investing in a loch boy

[brian c]

great wee video for 3 way mitre.Lock boys are ok aswell mate for hloes only in ceramics no good for porcelain u need a core cutter for those bad boys.

[tictic]

am sure if your members, that are not that long in the tile fixing trade....

practise these two videos they will have a little more confindence when working with tiles,and not get to much off the..squeaky bum......

off course, as has been said there are lots off devices out there to help you,but sometimes using just a couple off basic tools does the job just as good IMO.....

enjoy....

[Bubblecraft]

Don't mind doing these mitres in plastic but metal trim is a pain in the neck!