Help with tile trim - cuttin internal corners

[clive]

Hi. Really struggling to cut 6mm tile trim to join in a right angled internal corner.

I've tried cutting 2 pieces at 45 degrees, but this leaves a gap in the bit of the trim that meets the tile. Any tips out there please - preferable with pics. I've looked at the 3way mitre pics, but that doesn't really help for this type of cut.
Ta.

[doug boardley]

have you tried them in a mitre box? if you're trimming round, say, a window, you stand the trim on it's flange edge and do the 45dg cuts, If you're tiling a table top scenario, you put the trim so the flange sits flat in your mitre box and then do your 45dg cuts.
Hope this makes sense

[deanotile]

as above

[Dave]

If the internal corner is out of square, this could be why you cannot get the joint correct cutting at 45.. Try closing the cutting angle to get a tighter joint.