| Notices | Unregistered; We can see that you haven't yet posted anything. Please consider posting an informal introduction message in the 'New Members Say Hi Here' forum category. If you're not registered then please feel free to sign-up, it's FREE, and we don't bite!
---------- Checkout the Tile Business Network. It's FREE to join and can help put you in touch with the right people at the right time! Suppliers, Distributors, Manufacturers, Training Establishments and Tile Contractors ALL WELCOME. www.tilerstilingtiles.co.uk
---------- We've updated two of our external website's. Pro Tiling Tools and Tiling Courses Companies. Please check those out when you have a moment free.
---------- Please consider chatting live to other forum members in our Live Tile Chatrooms. From 8pm nightly every day of the week. The chatroom IS open 24/7 though.
---------- | Tiling Forum Discussions on all aspects of tiling & installing tiles in the tiling forum. |
18-10-2007
|
#1 | | Guest | Ignorant Newbie with Travertine Query | | Hi to all
I've had a little look around the site which is very helpful but I'm still at the deciding stage.
Just discovered Travertine and just loved the rough whitish tile I saw with holes and pits (guessing it's "unfilled"). My hubby thinks it might be unsuitable.
So, it would be for our kitchen and we have a dog with muddy paws in winter.
The kitchen has just been extended and half the floor has terracotta tiles laid on cement (rather uneven) - we've been advised to tile over the top of these. Other floor is the new bit and this is timber. We've been told to lay plywood onto this.
So would Travertine be suitable or not?
Also, with all the sealers I've been reading about, would they take away the rough almost chalky surface which I think is so nice? Would dirt collect in the pits and cracks despite sealing?
Can it be taken up the wall slightly to form a skirting board? I'm guessing would be too heavy to be a wall tile as such.
Also if it is suitable, any advice on best places to look for buying or anything to be wary of?
I'm cheeky and asking lots but any help would be much appreciated. | | |
| |
18-10-2007
|
#2 | | Tilersforums Black Prince | Re: Ignorant Newbie with Travertine Query | | Hello there.
Sealed propperly and you shouldn't have problems with dirt.
Cheeky for asking lots of questions ? , that's what everyones here for  , welcome to the forums | | |
| |
18-10-2007
|
#3 | | Tilers Forums Admin | Re: Ignorant Newbie with Travertine Query | | Quote:
Originally Posted by Mactavsy Hi to all
I've had a little look around the site which is very helpful but I'm still at the deciding stage.
Just discovered Travertine and just loved the rough whitish tile I saw with holes and pits (guessing it's "unfilled"). My hubby thinks it might be unsuitable.
So, it would be for our kitchen and we have a dog with muddy paws in winter.
The kitchen has just been extended and half the floor has terracotta tiles laid on cement (rather uneven) - we've been advised to tile over the top of these. Other floor is the new bit and this is timber. We've been told to lay plywood onto this.
So would Travertine be suitable or not?
Also, with all the sealers I've been reading about, would they take away the rough almost chalky surface which I think is so nice? Would dirt collect in the pits and cracks despite sealing?
Can it be taken up the wall slightly to form a skirting board? I'm guessing would be too heavy to be a wall tile as such.
Also if it is suitable, any advice on best places to look for buying or anything to be wary of?
I'm cheeky and asking lots but any help would be much appreciated. | seal with lithofin stain stop then it wont alter the stones appearance to much...you could tile over the old tiles but make sure they are well stuck and use a cleaner to remove all the polish off the top of them so the adhesive will get a good bond...where the concrete meets the new timber floor then you will have insert an expansion joint here ( right over the joint ) as the two sub-strates will expand at different rates thus causing one or both to de-bond, you could use a pre-formed expansion joint or form your own by using a silicone joint min 6mm in width.....be careful when buying as some cheap stuff is heavy calcareous and can make it weak at this point..better to go for a filled one as it will make cleaning easier with the dog ..etc........dave.. | |
Last edited by Dave; 18-10-2007 at 07:29 PM.
|
| |
19-10-2007
|
#4 | | New TilersForums Contributor
Join Date: Oct 2007
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
| Re: Ignorant Newbie with Travertine Query | | I'm no expert - all my info has come from readin message boards like this but I'm in a similar situation to you. We already have some of the same tiles that my Mum bought ages ago, and gather that they defintely need to be filled with grout or caulk (if that's the right word) - grout is preferable but more time consuming. Unfilled will gather dirt and mould. If you can get filled an honed that would probably be the best option for you.
If it's unpolished (honed), any etch marks from acids spilt on it will be less visible. Polished travertine in a kitchen sounds like it will get damaged more visibly. Honed travertinewill be less likely to etch from things like lemon juice, vinegar etc.
Tha's what I have gathered whilst doing my research, but anyone feel free to correct me. | | |
| | Discuss Ignorant Newbie with Travertine Query at the Tiling Forum within the TilersForums.co.uk | Tile Forums | Tiling Forum; Hi to all
I've had a little look around the site which is very helpful ... | Thread Tools | | | | Display Modes | Linear Mode |
Posting Rules
| You may not post new threads You may not post replies You may not post attachments You may not edit your posts HTML code is Off | | | All times are GMT. The time now is 04:00 AM. | |