Help!: Chisel edge travertine

[Jacaboy]

I'm a property developer in the middle of laying a 200m2 travertine floor and would really appreciate some advice. The vast majority of cuts are to be hidden under skirts but we have a quite a few that will abut dressed stone walls.

With the chisel edge to the tiles, we'll end up with a square edge against the wall. Any ideas on how to easily dress the cut edge?

May be the clue is in the name and I just grab a chisel but thought it best to ask some experts as there is probably a trick to this.

Thanks in advance for any help

[TilingLogistics]

I'm a property developer in the middle of laying a 200m2 travertine floor and would really appreciate some advice. The vast majority of cuts are to be hidden under skirts but we have a quite a few that will abut dressed stone walls.

With the chisel edge to the tiles, we'll end up with a square edge against the wall. Any ideas on how to easily dress the cut edge?

May be the clue is in the name and I just grab a chisel but thought it best to ask some experts as there is probably a trick to this.

Thanks in advance for any help

This can be achieved by using a good quality SDS drill fitted with a flat edge chisel. You may require a stiff rotating wire brush to tidy up any really ragged bits. I state good quality because an SDS such as my Makita has virtually infinite control on the trigger where as the cheaper ones don't

Kev

[CJ]

I have done similar using a wet cutter...........just angle the travertine and cut small notches/bumps on the cut side

Well........I know wot I mean.......and it worked for me

[Dave]

Snips...and touch in with wire wool......

[TilingLogistics]

Snips...and touch in with wire wool......

You must have wrist muscles like Tarzan I suppose if the snips break you could always bite a few bits out

Kev

[TilingLogistics]

I have done similar using a wet cutter...........just angle the travertine and cut small notches/bumps on the cut side

Well........I know wot I mean.......and it worked for me

Didn't it look to uniform?

Kev

[Dave]

You must have wrist muscles like Tarzan I suppose if the snips break you could always bite a few bits out

Kev

Of course......

[Jacaboy]

Fantastic help. Thanks Guys.
Not sure how long my snips will last but we're getting there.

Cheers