Tile Giant have sold me Keraflex maxi for my porcelain to wood floor project.
Have just looked at the data sheet and Mapei suggest that is is NOT suitable for a wooden floor. I have a 22mm marine play base, very well fixed.

Any advice for me out there?

i would disagree since it's an s1 flexible adhesive,i may be wrong but

So you think it would be ok? Should I prime?

You can use keraflex maxi on marine ply.

only prime the underneath and sides of the ply,not the surface you are tiling onto

imo, i would go for a rapid set flexi adhesive, its just what i prefer

It does take a long time to go off!

Of course it is suitable for tiling to timber.. A rapid set would be better regarding the moisture in the adhesive but keraflex maxi is suitable for timber.

Check out the black book centre pages for info>>> MAPEI - PDF Flip Pages

I use 2 part when tiling onto ply but only as a bit of over kill. You should be fine with the keraflex, as said above, the only problems would be the setting time.

It's fine as above. It has a long pot life so might be good if your new to tiling or want to take a bit extra time.

Here is a data sheet
100_Keraflex Maxi_uk.pdf

Not exactly new to tiling but not exactly fast (hence prefer a long set time) They are Villeroy Fire and Ice, hard as hell so everything wet cut and VERY slow.

Thanks all for your advice

No probs any time..

Originally Posted by jamesknox

Not exactly new to tiling but not exactly fast (hence prefer a long set time) They are Villeroy Fire and Ice, hard as hell so everything wet cut and VERY slow.

Thanks all for your advice

you could dry lay a certain amount and do your cuts , then do a mix with rapid set,but if ya happier with a slow set, go for it

Originally Posted by jamesknox

Not exactly new to tiling but not exactly fast (hence prefer a long set time) They are Villeroy Fire and Ice, hard as hell so everything wet cut and VERY slow.

Thanks all for your advice

Oh dear!! they're the hardest tiles I've ever had to cut