Which BAL Grout - TilersForums.co.uk | Tile Forums

What Tiler · 02-04-2008

Hi

I'm tiling a bath/shower room and have used BAL two part Flex adhesive on aquapanel for the tiles.

I am now about to grout and when I go on Powerspec onthe BAL web site it recommends I use Easypoxk as the grout.

After reading some of the threads on the site it seem difficult to use. What other grout would you suggest Superflex or Microflex wide joint?

Tile size is 250 x 400mm and gap about 4/5mm.

Thanks

WT

**grumpygrouter** · 02-04-2008

BAL Microflex will do fine. Out of interest, why did you use a 2 part flexy are you talking about the floor here?

Grumpy

**Dave** · 02-04-2008

I would use the micro flex as well.........good luck....

What Tiler · 03-04-2008

Quote:

Originally Posted by grumpygrouter

BAL Microflex will do fine. Out of interest, why did you use a 2 part flexy are you talking about the floor here?

Grumpy

No this is on the wall. I was probably being over cautious? Again I just used the Powerspec. site for a recommendation.

**grumpygrouter** · 03-04-2008

You certainly was being a bit over cautious WT. Single part flexy would have been sufficient, cheaper and probaably much less messy. But hey, if the customer was happy to pay the extra for fast flex, good on yer! It least the tiles most definately won't be coming off in a hurry.

Grumpy