Quote:
Originally Posted by Mactavsy  Hi to all
I've had a little look around the site which is very helpful but I'm still at the deciding stage.
Just discovered Travertine and just loved the rough whitish tile I saw with holes and pits (guessing it's "unfilled"). My hubby thinks it might be unsuitable.
So, it would be for our kitchen and we have a dog with muddy paws in winter.
The kitchen has just been extended and half the floor has terracotta tiles laid on cement (rather uneven) - we've been advised to tile over the top of these. Other floor is the new bit and this is timber. We've been told to lay plywood onto this.
So would Travertine be suitable or not?
Also, with all the sealers I've been reading about, would they take away the rough almost chalky surface which I think is so nice? Would dirt collect in the pits and cracks despite sealing?
Can it be taken up the wall slightly to form a skirting board? I'm guessing would be too heavy to be a wall tile as such.
Also if it is suitable, any advice on best places to look for buying or anything to be wary of?
I'm cheeky and asking lots but any help would be much appreciated. |
seal with lithofin stain stop then it wont alter the stones appearance to much...you could tile over the old tiles but make sure they are well stuck and use a cleaner to remove all the polish off the top of them so the adhesive will get a good bond...where the concrete meets the new timber floor then you will have insert an expansion joint here ( right over the joint ) as the two sub-strates will expand at different rates thus causing one or both to de-bond, you could use a pre-formed expansion joint or form your own by using a silicone joint min 6mm in width.....be careful when buying as some cheap stuff is heavy calcareous and can make it weak at this point..better to go for a filled one as it will make cleaning easier with the dog ..etc........dave..