Hello to all,
here goes, I have laid an anhydrite floor screed over a piped UFH system. On this i used a few coats of BAL apd and used flexy cement based ady and grout. The floor was 60 sqr meters and was limestone in an opus pattern. It looked stunning when it was done, all good so far. Then I foolishly used a acid based cleaner to try to remove the stubbon grout from the pitted surface. Massive mistake. This is in my new dream home which I have renovated myself. Gutted. Lots of faded light patches, looks shocking. I will notice every bit that is wrong every time I sit in the room if I don't repair it. The only time it looks at its best again is when its wet, when I have been coating it with impregnating sealer. I have paid 70 quid for a colour enhancer, it looks great when it is wet but when it dries it goes back to the streaky pattern. So my question is, is there a product that I can add to the surface that keeps it looking wet (preferably matt) and so keeping the colour even, or have I really, really messed up?